Circuit And Packet Switching

Submitted By frankarteaga
Words: 502
Pages: 3

Circuit & Packet Switching
NTC/362
July 30, 2014

Circuit Switching
The Circuit switching was the first to technique every utilized for the communication of networks, due to the fact that it is easy to carry analog signals. The circuit may also be circuit that is formed on an as-needed basis or a fixed one that is always present. There are a lot of possible paths through in between devices that can happen between both devices communicating and only one will be utilized to set dialog. The most common example of the circuit-switched network would be the telephone system. Once a call is placed to anyone and they answer on the other end, you have established a circuit connection and can allow data between be a steady stream. Usually the circuit functions in the identical way, in spite of the many in between devices are utilized to transfer the voice. This may be used for a long period of time, and then circuit ends. So the next time a call is placed; there is a new circuit, which usually uses different hardware. This is based on what the first circuit did. It can depend on the access the network as at that time. Below is Figure 1 that shows an illustration of a circuit switch network. In a circuit-switched network, a circuit is established between them, before communication can occur between both devices. Figure 1 shows a line that is blue for the channeling of data from Device A to Device B. Then a similar purple line from Device B back to Device A. Once it’s setup and organized. Most of the communications within these devices take place over this circuit. However, there are further possible ways that the data could perhaps be delivered between the devices over the network.

Figure 1
Circuit Switching

Packet Switching
Packet switching is known as the source for the Internet Protocol (IP). Packet switching is information that flows are usually broken into variable-size packets. The data is basically