When a bike is clean, it makes it easier to see if anything is broken or needs replaced. When cleaning a bike, low pressure water should be used so that water does not breach electrical components. Electrical components can short out and cause the bike not to start. Electrical components make up a lot of a newer dirt bikes components. Dirt should not be pushed or forced into places where it can’t be reached. When washing a bike, it should be considered about taking all of the bodywork and plastic off so that it gets every nook and cranny clean. An exhaust plug should be placed in the muffler and the air filter should be removed. An air filter cover should be put in the place of the air filter so water and dirt does not penetrate the cover and cause the bike to get water in the engine and harm it. The bike should be left to air- dry and later inspected for problems and broken parts. Compressed air should not be used because it can push any left-over dirt and water into places where it should not be and damage gaskets and bearings in the