Investigating The Relationship Between Resistance And Surface Area

Submitted By SebastianHigham1
Words: 1477
Pages: 6
Open Document
Introduction:
The equation we use to find the resistance from the current and voltage is:

Resistance (R) = Voltage (V) ÷ Current (I)

Put more simply, it is the number of volts difference across the object when one amp of current flows. You should recall that voltage is the number of joules of energy transferred by one coulomb of charge, and that current is the number of coulombs of charge passing a place each second.

The resistance of a conductor of uniform cross-section depends on three factors:
1. The length (l ) of the conductor. The longer the length, the greater the resistance will be.
2. The cross-sectional area (A). The greater the cross-sectional area, the less the resistance will be. This is similar to pumping water through a thick pipe compared with pumping it through a thin pipe: it is easier with a thick pipe.
3. The type of material the conductor is made of. Some materials are better conductors of electricity than others. This depends on the atomic structure of the material and how many free charge carriers there are to provide the current. The property of a material, which contributes to resistance, is its resistivity (ρ — the Greek letter ‘rho’). The unit of resistivity is the ohm metre (Ω
Mathematically:

For those of you who investigated the relationship between resistance and surface area, the area of each of the wires is as follows: Wire 1: 0.156 m2 Wire 2: 0.376 m2 Wire 3: 0.560 m2 You will need to draw a graph of resistance against area.
Aim: Determine, whether surface area of a wire affects current.
Hypothesis: The larger to surface area is on the wire, the more current allows flowing through.

Variables:
Independent – The independent variable will be the surface area of the wire. This was changed by keeping the length measured between negative and positive wires the same, but changing the thickness of the wire (thicknesses present above). The thickness is changed in order to directly measure the dependent variable.
Dependent – The dependent variable will be the measure of current that flows through the wire in between a constant distance (50cm). The current is measured to test accurately whether the hypothesis is correct and therefore can be supported.
Variables kept the same: * Wire length (50cm) * Voltmeter * Power Pack
Equipment:
* Retort Stand * Stopwatch * Rubber ball with string connected (at least 1m in length) * Retort Clamp
Method:
1. Collect all equipment from the given list 2. Use a lead to connect from the negative of the power pack to one end of the wire with a crocodile clip, another lead is connected from the first lead onto the wire to one end of the voltmeter 3. Use three leads to connect the ammeter to the other end of the wire with a crocodile clip, one lead from the voltmeter connecting into the lead on the wire, then another lead from the ammeter to the positive of the power pack. 4. Method from Practical: 5. Set up the circuit first using the steps above 6. Measure the distance between the two alligator clips and keep it constant for each test, we chose 50cm 7. Turn on the power pack to 10 volts and record the numbers on the ammeter and voltmeter in a table. 8. Move the alligator clips onto the second wire with a smaller cross sectional area to the first 9. Record the numbers on the ammeter and voltmeter in the table 10. Move the alligator clips onto the thinnest wire 11. Record the number on the ammeter and the voltmeter in the table 12. Repeat steps 3-7 3 times each
The hypothesis will be supported if there is a clear increase in current as the thickness/cross section of the wire increases accordingly. The thicker the wire present, the more current is able to flow through.
Results
Thickness (m2) | Amps (x10-3) | Volts | Length (m) | (Ὼ) | | 1 | 2 | 3 | Ave | 1 | 2 | 3 | Ave | | | 0.560 | 5.86 | 6.02 | 5.99 | 5.96 |
Show More

Related Documents: Investigating The Relationship Between Resistance And Surface Area

Essay on Jameswesthw4 Copy

June 28, 2015 Program Description This program will calculate the area and perimeter of the rectangle. It will prompt the user to input the length and width of the rectangle and calculate the area and perimeter from those values. Analysis The program will use sequential, repetition, and selection statements and functions for the area and perimeter calculations. I will define another as an integer I will define length, width, area, and perimeter as floats I will set ‘another’ equal to 1. This variable…

Words 780 - Pages 4

Investigation – Von Koch’s Snowflake Curve Essay

perimeter and area of Von Koch’s curve. [pic] The Koch’s curve has an infinite length because each time the steps above are performed on each line segment of the figure there are four times as many line segments, the length of each being one-third the length of the segments in the previous stage. First of all I am going to suppose c1 has a perimeter of 3 units. I will try to find the perimeter of c2, c3, c4 and c5. c1 s1 = 1 (s – side length) c2 s2 = 1/3…

Words 1562 - Pages 7

Essay about Sine and Cosine Rules and 3D Trigonometry

use the sine and cosine rules to find the length of sides and angles in triangles; * to use the formula for the area of a triangles; * to solve problems involving the sine and cosine rules; * to solve problems involving trigonometry in 3 dimensions. Brief recap of Grade B and C material: Pythagoras’ Theorem: This theorem, which connects the lengths of the sides in right-angled triangles, states that: where c is the length of the hypotenuse (i.e. the side opposite…

Words 2534 - Pages 11

Measurment: Volume and Area Essay

unit of length in the metric system. (a) When converting to a larger unit, divide. (b) When converting to a smaller unit, multiply. 1 cm = 10 mm1 m = 100 cm1 km = 1000 m The perimeter of a shape is the total distance around that shape. For circular figures the term circumference is used instead of perimeter. A formula can be used to find the perimeter (or circumference) of each of the following shapes. (a) Square P = 4l (l = side length) (b) Rectangle P = 2(l + w) (l = length, w = width)…

Words 932 - Pages 4

The Difference between Precision and Accuracy Essay

difference between precision and accuracy. One person measured the length of a laboratory table with a 20cm wooden rod while another person measured the width of the same laboratory table with a separate 20cm wooden rod. This was repeated 30 times. Data was collected to find the mean, standard deviation, percent discrepancy, relative error, and the normal distribution. Later in the experiment, the actual value of the length and width of the laboratory table was measured with a measuring tape…

Words 833 - Pages 4

Final Five Wishes Rubric Essay

Student: 8 7 6 5 0–4 Work Habits Superior work in all areas—Student consistently exceeds minimal expectations in all areas regarding content analysis, synthesis, evaluation of topics, participation, timeliness, and writing style Good work in most areas. Students demonstrates minor deficiencies in some areas regarding content, analysis, writing style, and/or participation. Fair work in most areas. Student exhibits need for improvement in most areas regarding content, analysis, writing style, and/or participation…

Words 387 - Pages 2

Essay about Factors Affecting Resistance of Pencil Lead

Factors Affecting Resistance of Pencil Lead Abstract: The investigation involved testing the factors of pencil lead length, cross-sectional area, temperature and lead type to find out how they affected pencil resistance. The hypothesis was proven as the length (series circuit) graph was exponential and the area (parallel circuit) graph was that of a power function. Higher clay based pencils (2H) had higher resistance to that of higher graphite based pencils (6B), and temperature…

Words 1851 - Pages 8

Pt1420 Unit 2 Assignment

World had no problems with the new design. Strengths The use of integration techniques and mathematical modelling to accurately plot a cross section, and then determine its area. Furthermore, the use of mathematical reasoning to assist in the calculation of the total volume of an irregular three-dimensional object, given the area of one of its…

Words 790 - Pages 4

LAN, Category 5 Essay

A local area network (LAN) supplies network capabilities to groups of computers that are in a small geographical area. These areas can include office buildings, schools and homes. A LAN delivers applications to local users, and provides the infrastructure for group collaboration, file sharing and transfer, and printing along with many other applications. Many local area networks are constructed from inexpensive hardware such as Ethernet cables, network adapters, and hubs. Although most local…

Words 566 - Pages 3

Young's Modulus Of Elasticity Lab Report

Theory The theory required for this experiment can be simplified to the followed equations. E=Stress/Strain= σ/ϵ= Fl/Ax E = Young’s modulus F= Force X = extension L = gauge length X = CSA (Cross sectional area) Yield Point=F/CSA F= force at point which plastic deformation stars UTS=F/CSA F = maximum force applied Equipment/ materials Description Quantity Experiment equipment Marker Pen 1 Experiment equipment Hounsfield…

Words 931 - Pages 4