Using Show Commands to Investigate Network Status vLab (15 points)
Write a paragraph (minimum five college-level sentences) below that summarizes what was accomplished in this lab, what you learned by performing it, how it relates to this week’s TCOs and other course material, and just as important, how you feel it will benefit you in your academic and professional career. (3 points)
In this lab I learned how to use show commands to display a variety of information. This information includes, but is not limited to verify the system hardware and version, determine amount of flash, and to verify frame relay mappings. I also learned how to create a detailed network diagram. This was accomplished using only show commands.
Copy and paste the following screenshots from your Using Show Commands to Investigate Network Status lab.
Task 1, Step 2: Paste a screenshot showing the output of the show version command. Remember that when you see the word more at the bottom of the screen it means that you will need to see additional output. Press the space bar until you are back to the user mode prompt. You will need to take at least two screenshots in order to have the complete output. (1 point)
Question: What is the name of the IOS file being used by this device? Which memory system is used to store this file? flash:c2800nm-adventerprisek9-mz.124-15.T1.bin is the file being used by the device. The memory system being used to store this file is ROM.
*Hint* Read and study the explanations within the lab for assistance. (2 points)
Task 1, Step 6: Paste a screenshot showing the output of the ip route command. (1 point)
Question: What network(s) were learned by a dynamic routing protocol? Which dynamic routing protocol is being used by this router?
100.0.0.0/8 was learned through a dynamic routing protocol. RIP is being used .
*Hint* Read and study the explanations within the lab for assistance. (2 points)
Task 1, Step 10: Several of these router operations have been used in past experiments. However, you probably haven’t been exposed to many WAN protocols. A very popular WAN protocol is frame relay. Paste a screenshot showing mappings of the active DLCIs to the remote router’s IP address. (1 point)
Question: What is the address of the remote router interface?
The address is 172.41.4.5.
*Hint* Read and study the explanations within the lab for assistance. (2 points)
Task 5, Step 11: Paste a screenshot showing the neighboring devices to r1. (1 point)
Question: What are the device IDs of the neighboring device? Which router interface is connected to the switch?
The device IDs are sw1 and r2. Sw1 is connected to the switch.
*Hint* Read and study the explanations within the lab for assistance. (2 points)
Performing Switch Startup and Initial Configuration vLab (15 points)
Write a short paragraph (minimum five college-level sentences) below that summarizes what was accomplished in this lab, what you learned by performing it, how it relates to this week’s TCOs and other course material, and just as important, how you feel it will benefit you in your academic and professional career. (3 points)
In this lesson I learned how to encrypt passwords. I also learned how to set a Cisco switch back to defaults. We also learned how to configure a default gateway for a Cisco router. We also learned how to answer the yes/no questions that is sometimes prompted by the router.
Task 1, Step 2: Paste a screenshot after your execute the erase startup-config command but before you execute the
