If the TEDS information is not available then the remote device will send the query signal demanding the custom TEDS for the connected sensor to NCAP wirelessly using 2.4GHz link. If TEDS information is received from NCAP the device will proceed further else it will again send the query signal. On receiving the TEDS information the device will configure its front end according to the received information. Once initial configuration is done then the sensor are given supply. After the supply if there is any fault then device will actuate a alarm signal which will be transmitted to the NCAP wirelessly. On receiving this information the power to the socket will be switched off. If there is no problem when power is switched ON then the particular operating mode is configured. Once the configuration is completed the data acquisition from the sensor will be started and the sensed data is sent to NCAP